1Antenna Connection Terminals
Connect the included indoor FM antenna to the FM ANT terminal and connect the included AM loop antenna to the AM ANT and GND terminals. To heighten safety and reduce interference, connect the GND terminal to a good earth ground. For improving reception quality, you can connect outdoor FM and/or AM antenna to these terminals (See pages 27 to 29 for details.)
2FREQUENCY STEP Switch (General Model only)
Because the interstation frequency spacing differs in different areas, set this switch to the position suitable for the frequency spacing in your area.
Before sliding this switch, disconnect the AC power plug of this unit from the AC outlet.
3AUDIO SIGNAL Connection Jacks (for Audio Source Equipment)
Connect the inputs and/or outputs of your audio equipment.
4AUDIO/VIDEO SIGNAL Connection Jacks (for Video Source Equipment)
Connect the audio and video inputs and/or outputs of your video equipment. In place of the VIDEO jacks, the S VIDEO jacks can be used for higher resolution and improved picture quality if your VCR, monitor, etc. are equipped with
5CENTER OUTPUT Jacks
6REAR OUTPUT Jacks
7REAR SPEAKERS Terminals
When using the
8CENTER SPEAKERS Terminals
When using the
9Center Speaker Switch
Set to “C + D” when using two center speakers, or to “C OR D” when using only one center speaker.
0IMPEDANCE SELECTOR Switch
Select the position whose requirements your speaker system meets.
AGND Terminal
Connects the ground wire of the turntable to produce minimum hum. In some cases, however, better results may be obtained with the ground wire disconnected.
English
19