F6/F8
T8
E
EMU01504
Removing the Propeller
1)Straighten the cotter pin 1 and pull it out using a pair of pliers.
2)Remove the propeller nut 2, washer 3 and spacer 4.
3)Remove the propeller 5, washer 6 and spacer 7.
EMU01505
Installing the Propeller
CAUTION:
●Be sure to install the spacer and washer before installing the propeller, otherwise, the lower case and propel- ler boss may be damaged.
●Be sure to use a new cotter pin and bend the ends over securely, other- wise, the propeller could come off dur- ing operation and be lost.
1)Apply Yamaha Marine grease or Corro- sion resistant grease to the propeller shaft.
2)Install the spacer, washer and propeller on the propeller shaft.
3)Install the spacer, washer and the pro- peller nut, and then tighten the nut to the specified torque.
Tightening torque:
Refer to “SPECIFICATIONS” page
4)Align the propeller nut with the propeller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the propeller shaft hole after tightening to the specified torque, then tighten the nut further to align it with the hole.