Basic components

●Changing the display format

●Pressing the “ ” (mode) button chang- es the display format in the following pat- tern:

●Total hours→Trip hours→Display off

●Resetting the trip hours

●Simultaneously pressing the “ ” (set)

and “ ” (mode) buttons for more than 1 second while the trip hours are displayed resets the trip counter to 0 (zero).

NOTE:

The total number of hours the engine has been run cannot be reset.

EMU26690

Trip meter

This gauge displays the distance the boat has traveled since the gauge was last reset.

Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge

points to “ ” (trip). To reset the trip meter

to zero, press the “ ” (set) and “ ” (mode) buttons at the same time.

NOTE:

●The trip distance is shown in kilometers or miles depending upon the unit of measure- ment selected for the speedometer.

●The trip distance is kept in memory by bat- tery power. The stored data will be lost if the battery is disconnected.

EMU26700

Clock

Press the “ ” (mode) button repeatedly until the indicator on the face of the gauge

points to “ ” (time). To set the clock, be

sure the gauge is in the “” (time) mode. Press the “ ” (set) button; the hour display

will begin blinking. Press the “ ” (mode) button until the desired hour is displayed. Press the “ ” (set) button again, the minute

display will begin blinking. Press the “ ” (mode) button until the desired minute is dis- played. Press the “ ” (set) button again to start the clock.

NOTE:

The clock operates on battery power. Disconnecting the battery will stop the clock. Reset the clock after connecting the battery.

EMU26710

Fuel gauge

The fuel level is indicated by eight segments. When all segments are showing, the fuel tank is full.

ECM00860

CAUTION:

The Yamaha fuel tank sensor differs from conventional sensors. Incorrectly setting the selector switch on the gauge will give false readings. Consult your Yamaha dealer on how to correctly set the selec-

20