Yamaha 006IPTO-F0, WD83390

120 Chapter 10—Control Room Monitoring

DM1000 Version 2—Owner’s Manual

Solo Setup

For solo setup, press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo

page appears.

This page contains the following parameters:

ASOLO

This parameter turns the Solo function on or off. By default, it is set to Enabled.

BMODE

This parameter determines how the Solo function works. There are two options. The

setting affects only Input Channels.

•RECORDING...............In Recording Solo mode, soloed Input Channel signals are fed

to the Solo bus and output via the Control Room Outputs.

Other buses (Stereo bus and Bus 1–8) are unaffected by this

mode.

•MIXDOWN..................In Mixdown Solo mode, soloed Input Channel signals are fed

to the Stereo bus and output via the Control Room Outputs.

Unsoloed Input Channels are not fed to the Stereo bus while

the Solo function is enabled.

CSEL MODE

This parameter determines how the Input Channels will be soloed when you press the

[SOLO] button of each Channel. There are two options.

•MIX SOLO....................In Mix Solo mode, any number of channels can be soloed

simultaneously.

•LAST SOLO.................. In Last Solo mode, only one channel can be soloed at a time by

pressing the [SOLO] button. The Solo function that was previ-

ously enabled for channels is automatically cancelled.

Tip:

•Recording Solo mode is convenient when you wish to monitor certain Input Channels

while recording, since the Stereo bus and Bus 1–8 signals are unaffected

•Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed

soloed Input Channel signals to the Stereo bus during mixdown.