Yamaha 006IPTO-F0, WD83390

Using the Solo Function 121

DM1000 Version 2—Owner’s Manual

Control Room Monitoring

DLISTEN

This parameter determines the source of the Input Channel Solo signal: Pre Fader or

After Pan. When Pre Fader is selected, turning on the PAN button below the Pre Fader

option will solo the channel with the pan position speciﬁed by the Pan setting even if the

source precedes the fader. This parameter is effective only in Recording Solo mode.

ESOLO TRIM

This parameter enables you to trim the level of the Solo signal in the range of –96 dB to

+12 dB.

FSOLO INTERRUPTION

When this parameter is set to Off, soloed channel signals are not fed to the Control

Room Monitor outputs. To monitor the Control Room Monitor signals and soloed

channel signals separately, change the output patching so that the soloed channel signals

are output independently from the Control Room Monitor outputs, then turn the Solo

Interruption parameter to Off.

GSOLO SAFE CHANNEL

For Mixdown Solo mode, Input Channels can be conﬁgured individually so that they

are not muted when other Input Channels are soloed (Solo Safe function). Signals from

Input Channels with the SOLO SAFE CHANNEL button turned on are always fed to the

Stereo bus, regardless of the channels’ Solo function status. You can clear all Solo Safe

settings by turning on the ALL CLEAR button.

HAUX/SOLO LINK

When this check box is checked, you can solo or unsolo Aux Sends using the AUX

SELECT [AUX 1] - [AUX 8] buttons without having to switch to the Master layer (see

page 107).

IFADER/SOLO RELEASE

If this check box is checked, you can unsolo the channels by raising the channel faders

that were at the level of –∞ when the Solo function was turned on. If the faders were set

to higher than –∞, the channels cannot be soloed. This setting is not effective in Mix-

down Solo mode and for Output Channels.

Using the Solo Function

You can solo and monitor Input Channels, Aux Out 1–8, and Bus Out 1–8 using the

[SOLO] buttons on the top panel.

1 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo

page appears.

2Set the SOLO parameter to On and the SOLO INTERRUPTION parameter to

Off.

Set other parameters on the page, if necessary.

Tip: For example, if you set the internal effects processor’s return signal to Solo Safe, you

can monitor the soloed “processed (or wet)” signals.

Note: When you check the AUX/SOLO LINK or FADER/SOLO RELEASE check box, the

Solo setting is temporarily cancelled.