130 Chapter 11—Surround Functions
DM1000 Version 2—Owner’s Manual
6To change the Surround Channel to Bus Out assignment, move the cursor
to the SURR/BUS SETUP button, then press [ENTER].
The Setup | Surr Bus page appears.
ABUS1–BUS8
These parameters select channels to be assigned to the Bus Outs in 3-1, 5.1, and 6.1 Sur-
round modes.
BINIT
These buttons reset the channel assignment to the default setting.
7To change the assignment, move the cursor to the desired Bus parameter,
rotate the Parameter wheel to select a channel, then press [ENTER].
The channels are swapped between the selected Bus and the Bus to which the channel
assigned to the selected Bus was assigned previously.
8 Press the DISPLAY ACCESS [OUT PATCH] button repeatedly until the Out
Patch | Slot Out page appears, then make sure that each Bus Out is routed
to the desired channel on the digital I/O card.
To monitor signals routed to the digital I/O card in the surround environment, use sur-
round monitoring (see page 136).
Tip:
•Pressing the DISPLAY ACCESS [SETUP] button repeatedly also displays the Surr Bus page.
•Available Bus Outs vary depending on the Surround mode. For example, in 3-1 Surround
mode, Bus Outs 1–4 are available. In 5.1 Surround mode, Bus Outs 1–6 are available, and
in 6.1 Surround mode, Bus Outs 1–7 are available.
2
1