Setting the Input Channels from the Display 73
DM1000 Version 2—Owner’s Manual
6
Input Channels
EMeters
These meters indicate the signal levels of the currently-selected Input Channel and its
available pair partner.
F (Phase) section
You can reverse the signal phase of the currently-selected Input Channel. (See page 63
for more information.)
GDELAY section
This section enables you to set the currently-selected channel’s Delay function. (See
page 63 for more information.)
HPAIR section
This section indicates whether or not channels are paired. The heart icon ( ) is in one
piece when channels are paired. The heart icon is broken ( ) when channels are not
paired. (See page 76 for more information.)
■Viewing the Pan, Fader, and Aux Send Level Settings
To display the View | Fader page of a certain Input Channel, use the corresponding [SEL]
button or fader to select the desired channel, then press the DISPLAY ACCESS [VIEW] but-
ton, then the [F2] button.
Move the cursor to a parameter you wish to change, then rotate the Parameter wheel or
press the [INC]/[DEC] buttons to modify the setting.
APAN/ON/Fader section
•PAN control..................This control adjusts the currently-selected Input Channel’s Pan
parameter.
Press the [ENTER] button to reset the Pan control to Center.
•ON/OFF button........... This button turns on or off the currently-selected Input Chan-
nel.
•Fader.............................. This parameter sets the fader position of the currently-selected
Input Channel. The fader knob is highlighted when the fader is
set to 0.0 dB.
Press the [ENTER] button to reset the Fader to 0.0 dB.
BSURROUND PAN section
•SURROUND PAN........The Surround pan parameters for the currently-selected Input
Channel are displayed only when a Surround mode is selected.
See page 125 for more information on Surround pan.
5
6
321 4