6-39
CHAS
FRONT AND REAR BRAKES
WARNING
New
30 Nm (3.0 mkg)
WARNING
CAUTION:
40 Nm (4.0 mkg)
7 Nm (7.0 mkg)
EAS00642
ASSEMBLING AND INSTALLING THE REAR
BRAKE CALIPER
Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake com-
ponents as they will cause the piston seals
to swell and distort.
Whenever a brake caliper is disassembled,
replace the brake caliper piston seals.
Recommended brake fluid
DOT 4
1. Install:
brake caliper 1
(temporarily)
copper washers
brake hose 2
union bolt 3
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
“CABLE ROUTING”.
When installing the brake hose onto the
brake caliper 1, make sure that the brake
pipe a touches the projection b on the
brake caliper.
2. Remove:
brake caliper
3. Install:
brake pads
brake pad springs
brake caliper
brake hose holder
Refer to “REPLACING THE REAR BRAKE
PADS”.