7-5
ELEC
CHECKING THE BULBS AND BULB SOCKETS
EAS00732
CHECKING THE BULBS AND
BULB SOCKETS
Check each bulb and bulb socket for damage or
wear , proper connections, and also for continu-
ity between the terminals.
Damage/wear Repair or replace the bulb,
bulb socket or both.
Improperly connected Properly connect.
Incorrect continuity reading Repair or replace
the bulb, bulb socket or both.
TYPES OF BULBS
The bulbs used on this motorcycle are shown in
the illustration on the left.
Bulbs A and B are used for headlights and
usually use a bulb holder which must be de-
tached before removing the bulb. The majority
of these bulbs can be removed from their re-
spective socket by turning them counterclock-
wise.
Bulb C is used for turn signal and tail/brake
lights and can be removed from the socket by
pushing and turning the bulb counterclock-
wise.
Bulbs D and E are used for meter and indica-
tor lights and can be removed from their re-
spective socket by carefully pulling them out.
CHECKING THE CONDITION OF THE
BULBS
The following procedure applies to all of the
bulbs.
1. Remove:
bulb