YDP-223 Keyboard Stand Assembly
ENGLISH
53
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
•To disassemble, reverse the assembly sequence given below.

Remove the following parts from the package. 1. Attach the side panels to the pedal box.

2. Attach the rear panel.

Have a Phillips-head (+) screwdriver ready.

TIP
A headphone hanger is included in the YDP-223 package.
You can attach a headphone hanger on the YDP-223 to hang
the headphones (page 12).
Assembly Parts
6 × 25 mm long screws ×4 1
4 × 12 mm thin screws ×2 3
Cord holders × 2
6 × 16 mm short screws ×4 2
4
×
20 mm tapping screws
×
4
4
Pedal box
Rear panel
Main unit
Side
panel
(left)
Side
panel
(right)
Bundled pedal
cord inside
AC power cord
Side panel
(left)
Side panel
(right)
(1) Untie and straighten
out the bundled cord
attached to the bot-
tom of the pedal box.
Don’t discard the
vinyl tie, you’ll need it
later in step 5.
(2) Use the four 6×25 mm long
screws 1 to attach the
pedal box. First attach one
side panel, then attach the
other side panel.
(2) Secure the top of the
rear panel to the side
panel brackets using two
4×12 mm thin screws 3.
(3) Secure the bottom
of the rear panel to
the pedal box using
four 4×20 mm tap-
ping screws 4.
(1) Place the bot-
tom edges of the rear
panel on the feet’s pro-
truding edges, with the
panel slightly angled
as shown in the illus-
tration.
Then, align the top part
of the panel with the
side panels.