GEN
IMPORTANT INFORMATION INFO
OR
EB101030
LOCK WASHERS/PLATES AND COTTER PINS
1.Replace all lock washers/plates and cotter pins after removal. Bend lock tabs along the bolt or nut flats after the bolt or nut has been tightened to specification.
EB101040
BEARINGS AND OIL SEALS
Install bearings and oil seals so that the manufacturer's marks or numbers are visible. When installing oil seals, apply a light coating of lightweight lithium base grease to the seal lips. Oil bearings liberally when installing, if appropri- ate.
1Oil seal
CAUTION:
Do not use compressed air to spin the bearings dry. This will damage the bearing surfaces.
1Bearing
EB101050
CIRCLIPS
1.Check all circlips carefully before reas- sembly. Always replace piston pin clips af- ter one use. Replace distorted circlips. When installing a circlip 1 , make sure that the
4Shaft