Yamaha DGX-630, YPG-635

DGX-630/YPG-635 Owner’s Manual 11

Setting Up

xAttach the stand bases.

Insert the joint connectors q into the stand boards as

shown. The joint connectors have been installed properly if

you can see the screw head on the connector.

Attach the stand bases to the bottom of the side boards,

using the screws w. The left and right stand bases are the

same shape, and there is no difference between their front-

to-back orientation. If you have trouble fastening the

screws, use a screwdriver to rotate the joint connectors so

that the connector holes are aligned with the screw holes

on the stand bases.

cAttach the back board.

Attach the back board, using the screws e. Check the

back-to-front orientation for the side boards. Make sure the

non-colored surface is facing down.

vAttach the support rail.

Spread the packing sheet on the ﬂoor. Place the instru-

ment on the sheet with the rear panel side on the bottom.

Align the support rail r into the groove on the bottom

of the instrument and attach the rail, using the screws t.

qJoint connectors

w6 x 70 mm

roundhead screws

e6 x 30 mm roundhead screw

t4 x 45 mm

ﬂathead

screws

rSupport rail

• If you put the connectors in wrong direction and want to take them out,

tap around the holes on the boards.

NOTE

• Be careful not to drop the back board or touch the sharp metal ﬁt-

tings.

CAUTION

• If you have purchased an optional pedal unit, attach the pedal unit

before proceeding to the next step. Refer to the instructions provided

with your pedal unit.

NOTE

• If you don’t have the packing sheet, use a thick blanket or other soft

material to protect the ﬂoor and the instrument.

NOTE