ASSEMBLY INSTRUCTIONS

OPERATING THE EZ-LINK™ SYSTEM

The EZ-Link™ system enables the use of these optional Add- Ons.

2.While firmly holding the add-on, push it straight into the EZ-Link™ coupler (Fig. 7).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 6).

Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r

Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r

Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TPAH*

Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . SS725r

Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TPPS*

Brushcutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TPBC*

*Do NOT use this attachment with an electric powered product.

WARNING: Before you begin using any attachment, read and understand the manual that came with the attachment. Follow all safety information contained within.

3.Turn the knob clockwise to tighten (Fig. 8).

CAUTION: Lock the release button in the primary hole (Fig. 7) and securely tighten the knob before operating this unit.

90˚ Edge

Trimming Hole

Removing the Cutting Attachment or Add-Ons

WARNING: To avoid serious personal injury and damage to the unit, shut the unit off before removing or installing add-ons.

1.Turn the knob counterclockwise to loosen (Fig. 6).

EZ-Link™ Coupler

Release Button

 

Knob

Guide Recess

Fig. 6

2.Press and hold the release button (Fig. 6).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the EZ- Link™ coupler (Fig. 7).

Release Button

EZ-Link™ Coupler

Primary Hole

Knob

Fig. 8

CAUTION: The add-ons with the coupler system are to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

For decorative trimming/edging with the line head cutting attachment, lock the release button of the cutting attachment into the 90° hole (Fig. 8).

Upper Shaft Housing

Lower Shaft Housing

Fig. 7

Installing the Cutting Attachment or Add-Ons

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1.Turn knob counterclockwise to loosen (Fig. 6).

6