INSTALLATION OF MEDIA
The Encore 2 can print continuous batches of labels or print and separate labels automatically using its built in label peeler. The following details how media installation for these two modes.
Peeler not in use (Journal, linerless, or batch quantities of labels)
1.Turn unit off.
2.Press and hold the “Open” button on the front of the unit. Rotate the top back to reveal the paper compart- ment
3.Remove the edge guide and install the paper roll on the spindle. Lead the free end over the rubber roller (platen). Paper should feed from the top of the paper roll.
4.Slide the edge guide back over the spindle and against the roll of media. Roll should be against the inside wall of the paper compartment.
5.Close the top and insure it is securely latched before beginning to print.
Peeler in use (Do not use the label peeler when printing a batch quantity of labels)
1.Turn unit off.
2.Press and hold the “Open” button on the front of the unit. Rotate the top back to reveal the paper compart- ment
3.Remove the edge guide and install the paper roll on the spindle. Lead the free end over the rubber roller (platen). Paper should feed from the top of the paper roll.
4.Lift peeler assembly by depressing “Open” button on
front of unit. Lead edge of stock over the peeler bar and under the grooved peeler roller. Stock should emerge from the slot in the front cover.
continued next page