Zebra Technologies S-500 2Operation, Operating Your Zebra Stripe Printer, Printer Operating Modes

2Operation

Operating Your Zebra Stripe Printer

Now that your printer is ready for operation, how does it work? The Zebra Stripe Printer is designed to receive instructions from a host computer, such as an IBM-compatible PC. To create a label, you will either need to write a format in ZPL II, which is a programming language for creating label formats, or you will need to use a software program designed to format labels for the Zebra Stripe Printer. If you are using label design software, refer to the instructions provided with your software package to determine how to proceed.

If you are using, or plan to use, ZPL II programming language to format your labels, make sure you have a copy of the ZPL II Programming Guide. This free guide was available at the time you ordered your printer, but if you do not have a copy then refer to the mail- or fax-in card in the front of this book to get a copy. For some sample ZPL II label formats, refer to the section at the end of this chapter. But first, we’ll describe the different operating modes.

Printer Operating Modes

The Stripe printer can be configured in several different operating modes by sending the proper commands from the host computer.

Tear-Off Mode

When the media is in the rest (idle) position, the webbing between labels is over the Tear-Off/Peel-Off Plate. To print a label, the printer first backfeeds the media until the start of the label is directly under the printhead then prints the entire label.

To print a large quantity of labels, send a format for printing a batch of labels to the printer; the printing will continue until all labels have been printed.

Peel-Off Mode (Factory-Installed Peel-Off Option Required)

When the media is in the rest (idle) position, the start of the label to be printed is slightly in front of the printhead. To print a label, the printer first backfeeds the media until the start of the label is directly under the printhead, then prints the entire label.

In this mode, once the label is printed, the media passes over the Tear-Off/Peel-Off Plate at a sharp angle. The backing material is peeled away from the label and winds around the Backing Rewind Spindle. The media feeds forward until most of the label hangs loose from the backing. The Label Available Sensor detects this label and pauses printing until the operator removes the label, then the next label prints.

The Backing Rewind Spindle will hold one-half of the backing from a standard-size media roll. The Rewind Spindle Full Sensor detects when the spindle is full and pauses

2

17