Zebra Technologies T300 Operating the System, BAR-ONEInstallation, Printer Operating Modes, Printing Method, B:), Run, Run, File, Start, A:\SETUP, B:\SETUP

Zebra 6300 Printer User’s Guide

BAR-ONE Installation

The Zebra T300 printer uses the Windows™-based BAR-ONE software or ZPL II Programming Language commands. To install BAR-ONE software:

1.Start Windows.

2.Insert disk 1 of the BAR-ONE software in your floppy disk drive (A: or

B:).

3.In Program Manager, click on the File menu. Select Run. (Windows 95 users: select Run from the Start menu.)

4.Type A:\SETUP (or B:\SETUP) and then press OK.

5.Follow the on-screen instructions to complete the installation.

Operating the System

To create a label for the Zebra T300, you may either use the BAR-ONE software to create the label format or write one in ZPL II , which is Zebra’s programming language for creating labels. If you are using BAR-ONE software, refer to the on-line BAR-ONE instructions. If you are using, or plan to use, the ZPL II programming language to format your labels, make sure you have a copy of the ZPL II Programming Guide. Refer to the mail-in/ fax-in card at the back of this book to obtain a copy, if desired.

Printer Operating Modes

Tear-Off Mode. The operator tears off each label (or a strip of labels) as it is printed.

Peel-Off Mode. The backing material is peeled away from the label as it is printed, the printer waits until the operator removes the label, then the next label is printed.

Cutter Mode. (Available only with Optional Cutter Module.) Each label is cut automatically after it is printed.

Printing Method

Thermal Transfer. (Requires use of thermal transfer ribbon.) The printer transfers ink/wax from a ribbon onto the media to form an image.

￿"