ZyWALL 5/35/70 Series User’s Guide
Figure 38 LAN IP Alias
The following table describes the labels in this screen.
Table 24 LAN IP Alias
LABEL | DESCRIPTION |
|
|
Enable IP Alias 1, | Select the check box to configure another LAN network for the ZyWALL. |
2 |
|
IP Address | Enter the IP address of your ZyWALL in dotted decimal notation. |
| Alternatively, click the right mouse button to copy and/or paste the IP address. |
|
|
IP Subnet Mask | Your ZyWALL will automatically calculate the subnet mask based on the IP |
| address that you assign. Unless you are implementing subnetting, use the subnet |
| mask computed by the ZyWALL. |
RIP Direction | RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a router to |
| exchange routing information with other routers. The RIP Direction field controls |
| the sending and receiving of RIP packets. Select the RIP direction from Both/In |
| Only/Out Only/None. When set to Both or Out Only, the ZyWALL will broadcast |
| its routing table periodically. When set to Both or In Only, it will incorporate the |
| RIP information that it receives; when set to None, it will not send any RIP packets |
| and will ignore any RIP packets received. |
RIP Version | The RIP Version field controls the format and the broadcasting method of the RIP |
| packets that the ZyWALL sends (it recognizes both formats when receiving). |
| is universally supported but |
| adequate for most networks, unless you have an unusual network topology. Both |
| |
| that |
| Multicasting can reduce the load on |
| not listen to the RIP multicast address and so will not receive the RIP packets. |
| However, if one router uses multicasting, then all routers on your network must |
| use multicasting, also. By default, RIP direction is set to Both and the Version set |
| to |
117 | Chapter 5 LAN Screens |