Chapter 5 EP Management

Table 19 EP Management > Ether > Config > Port (profile) (continued)

LABEL

DESCRIPTION

Speed/Duplex

Select the speed and the duplex mode of the Ethernet connection on this port. Choices are

 

Auto, 10M/Full, 10M/Half, 100M/Full, 100M/Half. Selecting Auto (auto-negotiation)

 

allows the port to negotiate with a peer port automatically to obtain the connection speed

 

and duplex mode that both ends support. If the peer port does not support auto negotiation

 

or turns off this feature, the EOC350-TA determines the connection speed by detecting the

 

signal on the cable and using half duplex mode.

 

 

Flow Ctrl

A concentration of traffic on a port decreases port bandwidth and overflows buffer memory

 

causing frame losses. Select On to enable flow control and regulate transmission of frames

 

to match the bandwidth of the receiving port.

 

 

Enable UpRate

Select Enable to throttle the upstream bandwidth through this port.

Limit

 

 

 

UpRate

Type a bandwidth value in 64Kbps increments. If this exceeds 1536 (100Mbps) on a

(*64Kbps)

termination adapter LAN port or 3125 (200Mbps) on an FoC port, there will be no bandwidth

 

throttling.

 

 

Enable

Select Enable to throttle the downstream bandwidth through this port.

DownRate

 

Limit

 

 

 

DownRate

Type a bandwidth value in 64Kbps increments. If this exceeds 1536 (100Mbps) on a

(*64Kbps)

termination adapter LAN port or 3125 (200Mbps) on an FoC port, there will be no bandwidth

 

throttling.

 

 

Apply

Click Apply to save your settings.

 

 

Back

Click Back to return to the previous screen.

 

 

5.7.3 The QoS Screen

Use this screen to prioritize traffic flow through the termination adapter’s interfaces. Click EP Management > Ether > Config > QoS on the default profile to show the following screen.

Figure 23 EP Management > Ether > Config > QoS (profile)

32

 

EOC350 Series User’s Guide