ZyAIR G-3000 Quick Start Guide

LABEL

DESCRIPTION

 

 

 

 

CONSOLE

Only connect this port if you want to configure the ZyAIR using the SMT (System

 

Management Terminal) via console port; see your User’s Guide for details.

 

Connect PS/2 end of the console cable to the console port of the ZyAIR and the other

 

end to a serial port (COM1, COM2 or other COM port) on your computer. Your computer

 

should have a terminal emulation communications program (such as HyperTerminal) set

 

to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and 9600

 

bps port speed.

 

 

 

 

ETHERNET

Use an Ethernet cable to connect a computer (with an Ethernet card) or switch to the

 

ETHERNET port. The port is auto-negotiating (can connect at 10 or 100Mbps) and auto-

 

crossover (automatically adjusts to the type of Ethernet cable you use (straight-through

 

or crossover)).

RESET

You only need to use this button if you’ve forgotten the ZyAIR’s password. It returns the

 

ZyAIR to the factory defaults (password is 1234 and LAN IP address 192.168.1.2). Refer

 

to the User’s Guide.

POWER

Connect the end of the included power adaptor to this power socket. You only need to

12VDC

connect the external power adaptor if you are not using PoE. If you simultaneously use

 

both PoE and the external power adaptor, the ZyAIR will draw power from the PoE

 

connection only.

 

 

 

 

 

 

Use only the included power adaptor.

 

 

 

EXTENSION

This slot allows you to add an IEEE802.11g or IEEE802.11b WLAN card adaptor. You

CARD SLOT

must have a WLAN card inserted before you can configure it.

 

The ZyAIR also contains a built-in wireless card.

 

 

 

 

2.2 The LED Display

When the power is connected the PWR, ZyAIR, SYS, WLAN LEDs turn on in that order. The ETHN LED turns on, if the ETHERNET port is properly connected. See the ZyAIR Front Panel LED Description table for more information.

5