ZyXEL Communications NOT AVAILABLE 11.2.1 Wireless Frame Capture Examples

Chapter 11 Wireless Frame Capture

The following table describes the commands available for wireless frame capture. You must use the configure terminal command to enter the configuration mode before you can use these commands.

Table 43 Command Summary: Wireless Frame Capture

COMMAND	DESCRIPTION
frame-capture configure	Enters sub-command mode for wireless frame capture.
src-ip {adddel} {ipv4_address	Sets or removes the IPv4 address of an AP controlled by
local}	the NXC that you want to monitor. You can use this
	command multiple times to add additional IPs to the
	monitor list.
file-prefix file_name	Sets the file name prefix for each captured file. Enter up
	to 31 alphanumeric characters. Spaces and underscores
	are not allowed.
files-sizemon_dir_size	Sets the total combined size (in kbytes) of all files to be
	captured.
exit	Exits configuration mode for wireless frame capture.
[no] frame-capture activate	Starts wireless frame capture. Use the no parameter to
	turn it off.
show frame-capture status	Displays whether frame capture is running or not.
show frame-capture config	Displays the frame capture configuration.

11.2.1 Wireless Frame Capture Examples

This example configures the wireless frame capture parameters for an AP located at IP address 192.168.1.2.

Router(config)# frame-capture configure

Router(frame-capture)# src-ip add 192.168.1.2

Router(frame-capture)# file-prefix monitor

Router(frame-capture)# files-size 1000

Router(frame-capture)# exit

Router(config)#

This example shows frame capture status and configuration.

Router(config)# show frame-capture status capture status: off

Router(config)# show frame-capture config capture source: 192.168.1.2

file prefix: monitor

file size: 1000

94
	NXC CLI Reference Guide