The following table explains the fields in this menu.
Table 88 Menu 15.1.1.1 Editing/Configuring an Individual Rule in a Set
FIELD | DESCRIPTION |
|
|
Type | Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are |
| the mapping types discussed in the web configurator NAT chapter. Server allows you |
| to specify multiple servers of different types behind NAT to this computer. |
Local IP | Only local IP fields are N/A for server; Global IP fields MUST be set for Server. |
|
|
Start | This is the starting local IP address (ILA). |
|
|
End | This is the ending local IP address (ILA). If the rule is for all local IPs, then put the Start |
| IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for |
| Server types. |
Global IP |
|
|
|
Start | This is the starting inside global IP address (IGA). If you have a dynamic IP, enter |
| 0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if |
| the types are |
End | This is the ending inside global IP address (IGA). This field is N/A for |
| |
Server | Only available when Type is set to Server. Type a number from 1 to 10 to choose a |
Mapping Set | server set from menu 15.2. |
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.
26.4 Configuring a Server behind NAT
Follow these steps to configure a server behind NAT:
1Enter 15 in the main menu to go to Menu 15 - NAT Setup.
2Enter 2 to display Menu 15.2 - NAT Server Sets as shown next.
Figure 138 Menu 15.2 NAT Server Setup
Menu 15.2 - NAT Server Sets
1. | Server | Set 1 (Used for SUA Only) |
2. | Server | Set 2 |
3. | Server | Set 3 |
4. | Server | Set 4 |
5. | Server | Set 5 |
6. | Server | Set 6 |
7. | Server | Set 7 |
8. | Server | Set 8 |
9. | Server | Set 9 |
10. | Server | Set 10 |
Enter Set | Number to Edit: | |
Chapter 26 Network Address Translation (NAT) | 236 |