P-871M User’s Guide

6 Push the power switch to the on position.

1.3 LEDs (Lights)

Look at the LEDs on the top panel of the P-871M.

•The POWER LED is on when the system is ready.

•The ETHERNET LED turns on if the ETHERNET port is con- nected to an Ethernet device and blinks when the P-871M is sending or receiving data through the ETHERNET port.

•The DSL LED is on if the VDSL connection between two P- 871Ms is set up.

•The CO LED is on when the P-871M is operating in CO mode.

If none of the LEDs (lights) are on, check your connections. Make sure that you have the power adaptor connected to the P-871M and plugged in to an appropriate power source. Make sure the power source is turned on. Turn the P-871M off, wait for a few seconds and turn it back on. If the LEDs are still off, contact your vendor.

5