Regulation, FCC Notice | AOC i2340Ve specification

Image 57

AOC i2340Ve manual Regulation, FCC Notice

Contents

c 2010 AOC.All Rights Reserved Power SafetyInstallation Cleaning Warranty Statement for Europe ServiceWarranty Statement for North & South America excluding Brazil EPEAT Declaration National Conventions Safety Power Installation Cleaning Other Contents in Box Setup Setup Stand & Base Please setup or remove the base following the steps as below SetupRemove Adjusting Viewing Angle Connecting the Monitor Adjusting Setting Optimal ResolutionWindows Vista 6 Set the resolution SLIDE-BAR to 1920 by 5 Click Display Settings 5 Click SETTINGS Windows XPFor Windows XP 2 Click CONTROL PANEL 3 Click Appearance and Themes Windows ME/2000 2 Click SETTINGS 3 Click CONTROL PANELFor Windows ME/2000 Source/Auto Hotkeyse-sensor Menu/Enter Basic and simple instruction on the control keys OSD Setting Luminance to enter, and press or to adjust Press to exitPress Menu to display menu Press or to select Luminance, and press to enter Press or to select submenu, press Adjust to Gamma1 Backlight AdjustmentAdjust to Gamma Enable dynamic contrast ratio Setup , and press Image Setupadjust Press to exit Press Menu to display menu reduce Color Temperature Press Menu to display menu Press or to select ColorTemperature, and press to enter Press or to select submenu, press Cool Normal Color Boost ColorBoost , and press Disable or Enable Nature Skin Mode Disable or Enable Full Enhance ModeDisable or Enable Green Field Mode Disable or Enable Sky-blue Mode Picture Boost Press Menu to display MENU Press or to select PictureBoost and press to enter Adjust Frame Brightness Adjust Frame SizeAdjust Frame Contrast Adjust Frame horizontal Position OSD Setup Adjust the horizontal position of OSD SetupAdjust the vertical position of OSD Timeout Extra Auto AnalogDigital Reset Press Menu to display menu Press or to select Reset, andpress to enter Press or to select YES or NO Press to exit Reset the menu to default Reset Exit Press Menu to display menu Press or to select Exit andpress to enter Full Power Mode LED IndicatorStatus LED Color Driver Monitor DriverWindows 4.Ckick on the “Change display settings” button 5.Click the “Advanced Settings” button6.Click the “Monitor” tab and then click the “Properties” button “Update Driver... “and then 7.Click the “Driver” tab9. Select Let me pick from a list of device drivers on my computer 13. Close all open windows and remove the CD 3. Click Advanced Settings 2. Click Personalization and then Display Settings 8. Select your monitor model and click on the Next button 5. Click Update Driver... in the Driver tab 2. Click on the Start button and then click on Control Panel 1. Start Windows XP3. Select and click on the category „Appearance and Themes‟ 4. Click on the Display Item 7. Click on the Driver tab and then click on Update Driver... button 5. Select the Settings tab then click on the Advanced button6. Select Monitor tab If the Properties button is active, click on Properties button 11. Click on the Open button, then click the OK button 12. Select your monitor model and click on the Next button13. Click on the Finish button then the Close button Windows ME i-Menu e-Sensor e-Saver Screen+ Problem & Question TroubleshootPower LED Is Not ON Ghosting Shadowing Problem Monitor Is Stuck In Active General Specification Specification Preset Display Modes Pin Assignments Plug & Play DDC2B Feature Plug and Play FCC Notice Regulation WEEE Declaration Only for North and South American, excluding Brazil EPEAT DeclarationFor Germany For Brazil Warranty Statement for Europe Service Information in this document is subject to change without notice Warranty Statement for North & South America excluding Brazil ARGENTINA http//ar.aoc.com/support/findservicecenter USA http//us.aoc.com/support/findservicecenterBOLIVIA http//bo.aoc.com/support/findservicecenter CHILE http//cl.aoc.com/support/findservicecenter