Avaya P330-ML-ML manual Copy tftp SWpowerinlineimage, Crypto key generate dsa

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

copy tftp SW_powerinline_image

User level: supervisor

This command applies to P333T-PWR switches only and is used by P330- ML-ML switches to control P333T-PWR modules in the stack.

Use the copy tftp SW_powerinline_image command to update the inline software application from a TFTP server to the memory of a designated module. You need to be in privilege mode to execute this command.

The syntax for this command is:

copy tftp SW_powerinline_image <image-file> <ip-addr> <mod-

num>
image_file	Common name for the file that contain the Power
	over Ethernet (PoE) Software image and the
	Embedded Web archive (full path)
ip_addr	IP address of the TFTP host
mod_num	Target module number
Example:

P330-ML-2# copy tftp SW_powerinline_image c:\p333t\p333T_203 192.168.49.10 5

Module:	5
Source file:	c:\p333t\p333t_203
Destination file:	Powerinline
Host:	192.168.49.10
Running state:	Downloading
Failure Display:	Access Violation
Last warning:
Download completed

Before executing the download, the following checks will be performed by embedded SW, on the TFTP server file:

—Ensure that the file size is within its allocated space.

—Check that the file contains embedded web SW for this application

—Verify file validity by calculating the checksum.

crypto key generate dsa

User level: supervisor

Use the crypto key generate command to create the host key.

32 Avaya P330-ML Reference Guide