Black Box 8-port 10/100base-tx hardened ethernet extender switch Command Line Console Management

Chapter 6: Command Line Console Management

Alarm Setting

Alarm-trigger if:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use this command to enable or disable alarm trigger on interface.

3. Command Syntax:

(no) alarm-trigger if INTERFACE INTERFACE specifies the interface.

4. Example:

The following example enables alarm trigger on interface “fe1” to Hardened Ethernet Extender Switch:

switch_a(config)#alarm-trigger if fe1 switch_a(config)#

Alarm-trigger power:

1. Command Mode: Configure mode

Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen.

switch_a(config)#

2. Usage:

Use this command to enable or disable alarm trigger of power source.

3. Command Syntax:

(no) alarm-trigger power POWER POWER specifies the power source.

LB308A 724-746-5500 blackbox.com Page 125