Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Use the following command to copy a file to flash memory.
Milo# copy tftp:filename [bootflash:slot0:slot1:] filename
Where:
•tftp:filename specifies the source and name of the file to be copied.
•[bootflash: slot0: slot1:] filename specifies the destination flash device and name of the file.
The destination flash device can be one of the following:
–
–
–slot
|
| The following is typical output generated using the copy tftp:filename command. | ||
|
| Milo# copy tftp:myfile1 slot0:myfile1 | ||
|
| 20575008 bytes available on device slot0, proceed? [confirm] | ||
|
| Address or name of remote host [1.1.1.1]? | ||
|
| Loading new.image from 1.1.1.1 (via Ethernet0): | ||
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| ! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !! |
|
|
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! | ||
|
| !!!!!![OK - 7799951/15599616 bytes] | ||
|
| CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC | ||
|
| CC | ||
|
| CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC | ||
|
| C | ||
|
| CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC | ||
|
| CC | ||
|
| Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide |
|
|
|
|
| ||
|
|
|
| |
|
|
| ||
