Chapter 2 Setting Up and Configuring the Multi Services Platform
Mounting the Multi Services Platform in a Rack
•Consider the connection of equipment to the power supply circuitry and the effect that possible overloading of circuits may have on overcurrent protection and power supply wiring. Consider equipment nameplate ratings when addressing this issue.
•Maintain a reliable ground. The rack itself should be grounded. Pay particular to power supply connections other than direct connections to the branch circuit (for example, power strips).
Rack Mounting
|
|
| To install the Multi Services Platform in a rack, perform the following procedure. |
|
|
| You will need a |
|
|
| Multi Services Platform chassis and to the rack. |
|
|
|
|
Note | • There are a variety of racks available. The procedure for your rack may be | ||
|
|
| slightly different than the following instructions. See the installation |
|
|
| instructions for your rack for additional information. |
|
|
| • The figures in these sections illustrate the 4 RU model. The procedures are |
|
|
| similar for 1 RU and 2 RU models. |
. |
|
|
|
|
|
| |
|
|
| Procedure |
|
| ||
Step 1 | Attach the inner rack rails to the Multi Services Platform. | ||
|
|
| There are two inner rack rails. One attaches to each side of the Multi Services |
|
|
| Platform. To attach these rails, see Figure |
| Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2 |
|
