Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
Initial 3545 MCU Configuration
Table
Requirements | Notes |
Subnet mask for the MCU if applicable
Domain Name Server and domain name for MCU if applicable
PC with available serial port and terminal emulator software installed
Procedure
Step 1 Connect the
Step 2 Connect the power cable.
Step 3 Start the terminal emulation application on the PC.
Step 4 Set the communication settings in the terminal emulation application on the PC as follows:
–Baud rate: 9600
–Data bits: 8
–Parity: None
–Stop bits: 1
–Flow control: None
Step 5 Turn on the power to the MCU.
A log of the
Step 6 When the message “Press any key to start configuration” appears on the screen, press any key within six seconds.
The network configuration Main menu appears as follows:
Press any key to start configuration...
Main menu
N: Configure default network port values
P:Change the configuration software password
S:Configure network security level
A:Advanced configuration menu
Q:Quit
Select:
Step 7 At the prompt, enter N to configure default network port values and press Enter.
Step 8 At the Enter IP address for default interface prompt, enter the IP address you want to assign to the MCU and press Enter.
Caution Do not use leading zeros in the IP address.
Step 9 At the Enter Default Router IP Address prompt, enter the IP address of the router associated with the segment in which the unit will be installed and press Enter.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Release 5.1
|
| ||
|
|
