Cisco Systems ASR9001s, 9001S manual Removing a Cable-Management Tray

Chapter 3 Installing Modules and Cables in the Chassis

Cable Management

Figure 3-7 Cable-Management Tray Installation and Removal

1

1Cable-Management Tray

332147

Step 3 Insert and tighten the captive screw(s) to secure the tray. (see Figure 3-7).

Step 4 Connect all the cables to the intended ports and pass them throught the cable management tray in an organized manner.

Removing a Cable-Management Tray

To remove a cable-management tray, follow these steps (see Figure 3-7):

Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2 Note the current interface cable connections to the ports on the RP.

Step 3 Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP interface.

Step 4 Repeat Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed to Step 5.

Step 5 Loosen the captive installation screw on the cable-management tray and remove the tray from the chassis (see Figure 3-7).

	Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02		3-13