Champion Level 1
USER MANUAL
4.Place the decuppeling base for the motor in the indent of the chassis and place the motor on it. The switch of the motor should be on the outside of the turntable and the space between motor and chassis approx. 1cm. (for an exact adjustment see chapter 4).
5.Please screw the tonearm carefully into the upper part of the tonearm base. Then slide the tonearm nut over the tonearmcable and tighten it, but not too much because the tonearm should be still able to turn.
6.Now you can While holding the unit you can adjust the tonearm height (VTA = vertikal tracking angle) when you have a cartridge mounted. The VTA is adjusted correctly if the tonearm sits parallel to the turntable platter surface after lifting it down. Now loosen the six screws with the provided hex key wrench, to be able to set the distance between the spindle and the tonarm bearing crosspoint to 222mm, by turning the tonearm base. After that you can fix the six srews again.
Page 6 | clearaudio electronic GmbH 2006 |
