Digicom 3910, 3911 operation manual DialDirectory01 Off Hook, Disconnect Command Complete

Call Setup Branch

Once the directory location you want appears on the LCD, press the F2 or F3 key to dial the number.

DialDirectory:01

Off Hook

F1 F2 F3

The Call Setup status Off Hook appears during the connection process. If the connection is successful, one of the Normal Operation status messages (Table 3-3 in Chapter 3, DCP Operation) appears on the LCD. If the connection is not successful, the LCD displays one of the Call Failure status messages (Table 3-3 in Chapter 3, DCP Operation).

Disconnect

For dial backup applications, use this function when you want to disconnect an established call on a dial line. For leased backup applications, use this function to switch between the primary leased line and the backup leased line.

To access Disconnect from the Call Setup branch, make the following selection:

Call	Setup:	>
Dial	Disconnect
F1	F2	F3

Select Disconnect.

Disconnect

Command Complete

F1 F2 F3

For dial backup applications, the modem goes on-hook (hangs up) and the call is disconnected. The Command Complete status message appears.

To exit this function and remain in the Call Setup branch, press the key. To exit and return

to the Top-Level menu, press the key.

3910-A2-GN32-40 September 1998 10-3