Emerson Process Management 53eA Temp units C Output 1 mA Output 2 mA, Display contrast Timeout On

MODEL 54eA	SECTION 5.0
	SOFTWARE CONFIGURATION

5.5 CHOOSING DISPLAY OPTIONS (CONTINUED)

Temp units: °C

Output 1: mA

Output 2: mA

ExitEdit

Language: English

Display left: I

Display right: Out 2

ExitEdit

Display contrast: 40

Timeout: On

Timeout value: 10 min

ExitEdit

8.Set the remainder of the display parameters. Use the é and ê keys to choose the desired parameter. Then press Edit (F4). Use the é key to move the cursor to the desired selection. Press Save (F4) to store.

Temp units	°C or °F
Output 1	mA or % of full scale
Output 2	mA or % of full scale
Language	English, Français, Español, Deutsch, Italiano
Display left	sensor current (I), pH (appears only if free chlorine
	is being measured and pH was enabled), alarm 1
	setpoint (no units), alarm 3 setpoint (no units),
	or blank
Display right	sensor current (I), pH (appears only if free chlorine
	is being measured and pH was enabled), alarm 2
	setpoint (no units), alarm 3 setpoint (no units),
	output 2, or blank
Display Contrast	00 (lightest)-99 (darkest); the display contrast
	changes as the number changes
Timeout	Timeout returns the display from any other screen
	to the main display if no key is pressed before the
Timeout value
	timeout value is exceeded.
Polling address	Identifies controller in multi-drop HART applications.

SECURITY CAUTION

The controller uses the timeout value to activate security. Once the controller is unlocked by entering a security code, security will not re-activate until a display timeout occurs. If timeout has been turned off, security will never reactivate.

29