Enterasys Networks CSX6000, CSX5500, CSX7000 DM card in slot slot # will not come out of reset

SYSTEM MESSAGES

System Message Summary

CFGEDIT. If the board is configured properly, and the message still appears, contact your Distributor or Customer Support.

DM card in slot <slot #> will not come out of reset

There are problems initializing the board. Contact your Distributor or Customer Support.

DM upgrade timeout. Board=<board #>, Modem=<modem #>

DM upgrade error during download. Modem says = xxx

DM upgrade no response at start. Board=<board #>, Modem=<modem # >

DM upgrade flash erase failed. Board=<board # >, Modem=<modem #>

DM upgrade no response at end. Board=<board #>, Modem=<modem #>

There were problems while attempting to update the firmware of the specified modem due to either a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or check the MVIP cabling. If problems persist, contact your Distributor or Customer Support.

DM upgrade started. Board=<board #>, Modem=<modem #>

The system has begun to update the firmware of the specified modem on the Digital Modem card. Watch for subsequent log messages to ensure the update is successful.

DM session in unknown upgrade state. Board=<board #>, Modem=<modem # >

There were problems while attempting to update the firmware of the specified modem due to either a corrupt firmware file or hardware problems. Contact your Distributor or Customer Support.

DM upgrade success. Board=<board #>, Modem=<modem #>

The system has successfully updated the firmware of the specified modem on the Digital Modem card.

DM: TimeSlot driver circuit id already in use on CREATE

DM: No TimeSlot driver circuits available for CREATE

DM: TimeSlot driver circuit id not in use on REMOVE

DM: TimeSlot driver circuit id not found on REMOVE

There were problems related to the Digital Modem’s use of the TDM bus. Contact your Distributor or Customer Support.

Downloading Bootstrap to DM card in slot <slot #>

Informational message stating that the system is attempting to initialize a Digital Modem card. Watch for subsequent log messages to ensure the initialization is successful.

Downloading DM card in slot <slot #> with operational software

Informational message displayed during a successful initialization. Watch for subsequent log messages to ensure the initialization is successful.

Downloading WAN card in slot <slot #> with operational software

Informational message during a successful system initialization. The status of the download process for WAN card in slot <slot #> is identified. This should be reported after the “Bootstrap came alive...” message for a given adapter.

DSL test failed to establish Layer 1, port=<port #>

During power up, all WAN lines undergo a test to see if Layer 1 can be established. This message indicates a test failure. Check the wiring. If correct, contact your phone company.

Central Site Remote Access Switch 499