FARGO electronic II manual Take-up Roll

24

5.Place the take-up end of the roll in between the two black Lamination Drive Hubs located on the far left-hand side of the printerÕs interior. Load the take-up end of the roll just as you loaded the supply end in step 4. When loaded properly, the overlaminate material should feed underneath both ends of the overlaminate roll.

IMPORTANT!

Supply Roll

Take-up Roll

6.Close the cover. When you start to print, the Lamination Drive Hubs will automatically engage the notches on both cores of the overlaminate roll.

Do not reverse the overlaminate roll. Damage may occur to the lamination roller!