Step, Name, Start µs, Amplitude, Length | Fluke 271 instruction

Image 31

Fluke 271 manual step, name, start µs, amplitude, length, VALS=ABS AUTO=YES STEP=00 ACTIVE LENGTH=0256 LEVEL=+511

Contents

Programmable 10 MHz DDS Function Generator Getting Started Manual To register your product online, visit register.fluke.com LIMITED WARRANTY AND LIMITATION OF LIABILITY Safety Getting Started Manual Alternating current Warning - hazardous voltages may be present Safety continuedThe following symbols are used on the instrument and in this manual Terminal connected to chassis ground Mains supply OFF Mains supply ONPage Emissions EMC ComplianceImmunity e EN61000-4-5 1995 Surge 0.5 kV line to line, 1 kV line to ground Title Table of Contents AUX OUT viii Mains Supply Voltage Getting StartedIntroduction Before You Start Externally Applied Voltages shx0001f.gif Controls and ConnectionsGetting Started Figure 1. Model 271 Front Panel Controls The Liquid Crystal DisplayFunction Keys FIELD and DIGIT Keys and the Rotary Control Numeric, Units and SET Keys RECALL and REMOTE MODE KeysUTILITIES Keys OUTPUT Key AUX OUT Front Panel Inputs and OutputsEXT TRIG MAIN OUT SYNC OUT Rear Panel ConnectorsCLOCK IN/OUT VCA IN TRIG/SWEEP OUT RS232 and GPIB Interface Connectors Check the LCD Display Using the InstrumentPlug in and switch on the instrument Starting up SYM=50.0% 50.0% Generating Continuous SignalsSet a frequency, for example 12.5 kHz FREQ=12.50000kHz VhiZ=+20.0 Vpp 50Ω DC=+0.00mV +0.00mV =80.00000us Set the amplitude to +10 dBmHave a look at some other waveforms Change the dc offset DC OFFSET CHANGE * * BY OUTPUT LEVEL Effect of the output attenuatorPER =80.00000us VhiZ=+4.00 Vpp 50Ω DC=+1.50 V +151.mV SYM=50.0% 50.0% Asymmetric waveforms Adjusting the phaseSOURCE=EXT TGEN=1.00ms 1.000kHz BURST COUNT= PHASE=+000 +000 SOURCE=EXT TGEN=1.00ms 1.000kHz BURST COUNT= PHASE=+116 +116 TRIG/SWEEP OUT signal Generating Swept Signals MODE=BEG-END LAW=LOG RAMP TIME=5.00 s TRIG SRC=CONTINUOUS MORE MODE=BEG-END LAW=LOG RAMP TIME=0.05 s TRIG SRC=CONTINUOUS MOREBEG FRQ=261.6000 Hz END FRQ=1.108700kHz MARK FRQ=523.3000 Hz MORE FREQ=2.000000kHz VhiZ=+20.0 Vpp 50Ω DC=+0.00mV +0.00mV SOURCE=EXT TGEN=1.00ms 1.000kHz BURST COUNT=0001 PHASE=+000 +000PHASE=+000 +000 Generating a Triggered Burst FREQ A=800.0000 Hz FREQ B=1.200000kHz SOURCE=TGEN FREE FSK ModeSpecial Waveforms Staircases Figure 2. 625-line PAL TV Signal amplitude stepname start µs VALS=ABS AUTO=YES STEP=08 ACTIVE LENGTH=0005 LEVEL=+153 VALS=ABS AUTO=YES STEP=01 ACTIVE LENGTH=0256 LEVEL=+000 RECALL ARB No ARB 03 IS EMPTY Saving and Recalling SettingsArbitrary Waveforms RECALL ARB No SINX/X ENTER TO EXECUTE Other Functions and Waveforms