Fujitsu IRMC S2/S3 manual Configure the following settings, Set the value to Enabled

Configuring the LAN interface of the iRMC S2/S3

ÊConfigure the following settings:

Service LAN

Set the value to Enabled.

Service LAN Port

The Service setting is recommended.

IThe Service setting is mandatory for the Type TX150 S6 PRIMERGY server.

DHCP

If you enable DHCP, the iRMC S2 gets its LAN settings autonomously from a DHCP server on the network. In this case, the values for Local IP Address, Subnet Mask, etc. are set automatically.

IDo not activate the DHCP option if no DHCP server is available. If you activate the DHCP option and there is no DHCP server available, the iRMC S2 goes into a search loop (i.e. it constantly searches for a DHCP server).You can specify that the DHCP and DNS services are to be used after initial installation, using the iRMC S2 web interface, for instance (see section "DNS Configuration - Configuring DNS for the iRMC S2/S3" on page 249).

By default, the following name is passed to the DHCP server on initial installation of the iRMC S3:

iRMC<last 3 bytes of the MAC address>.

Local IP Address

Enter the IP address you have determined for the iRMC S2 of the managed system.

Subnet Mask

Enter the subnet mask for the network. the iRMC S2 is connected to.

Gateway Address

Specify the IP address of the gateway of the network the iRMC S2 is connected to.

ÊSave the settings.

iRMC S2/S3 45