GB

Rotate cutting unit

For sideways cutting, the cutting unit can be rotated through 90°.

through 90°:

The cutting unit 4 can be turned to the right or left for right-

 

handed or left-handed users respectively.

 

 

4

3

Tilting the swivel head:

1

2

Extending the telescopic tube:

E D C B

1.Remove the battery from the handle (see 4. Initial Operation).

2.Keep button 3 pressed.

3.Turn cutting unit 4 90° in the required direction until the button 3 locks into place.

AV Check the lock!

4. Put the battery on the handle (see 4. Initial Operation).

A safety device prevents the Hedge Trimmer from starting up when the button 3 is pressed or not locked in 0° or 90° position.

For trimming at high and low level, the swivel head 2 can be tilted at an angle of 75° to -45° in 15° increments.

1.Remove the battery from the handle (see 4. Initial Operation).

2.Hold down the button 1.

3.Tilt the swivel head 2 in the direction wanted.

4.Release the button 1 and allow it to engage.

5.Put the battery on the handle (see 4. Initial Operation).

A safety device prevents the hedge trimmer from starting when the button is depressed or not engaged 1 or when the tilting angle exceeds -45° (packing position).

The telescopic tube C / E offers continuous extension for trimming at high and low level and can be extended in two stages to a total length of 62 cm.

1.Remove the battery from the handle (see 4. Initial Operation).

2.Open clamping lever B, extend the lower telescopic tube C to the length required and close clamping lever B again.

3.Open clamping lever D, extend the upper telescopic tube E to the length required and close clamping lever D again.

4.Put the battery on the handle (see 4. Initial Operation).

Starting the Hedge Trimmer:

G

F

DANGER ! Risk of physical injury!

AIf the Hedge Trimmer does not switch off auto - matically, there is a risk of lacerations.

V Never override the safety devices (e.g. by strapping down one of the start buttons).

Starting the Hedge Trimmer:

The hedge trimmer is fitted with a two-handed safety device (2 start buttons) to prevent the unit from being turned on by accident.

1.Put the battery on the handle (see 4. Initial Operation).

2.Remove the protective cover F from blade G.

18

Page 7
Image 7
Gardena 8882 manual Rotate cutting unit, Through, Tilting the swivel head Extending the telescopic tube