GarrettCom manual Introduction Magnum 6K25e Managed Fiber Switch Port Modules

	Magnum 6K25e Gigabit Fiber Switch						Installation and User Guide (10/07)
	6KPM-
		100Mb	Multi-	2	1300	62.5/125	-20	-31	9.0	3.0	14	5
MST, MSC		FX	mode	(0.4)		50/125	-23.5	-31	5.5	2.0	12	4
6KPM-SSC		100Mb	Single-	18+	1300	9/125	-15	-31	14	28	17.5	35
		FX	mode	(0.4)
	6KPM-	100Mb	Single-	40	1300	9/125	-5	-34	29	58	32.5	65
		FX	mode	(0.4)
	SSCL
	6KPM-	100Mb	Multi-	2	1300	62.5/125	-20	-31	9.0	3.0	15.8	5.5
	MTRJ	FX	mode	(0.4)		50/125	-23.5	-31	5.5	2.0	12.2	4.0
	6KPM-	100Mb	Multi-	2	1300	62.5/125	-19	-31	12	4	16	5.7
		FX	mode	(0.4)
	MLC
6KPM-SLC		100Mb	Single-	15+	1310	9/125	-15	-28	11	22	-	-
		FX	Mode	(0.4)
	GBIC-	1000Mb	Multi-	0.55	1300	62.5/125	-9.5	-17	5.5	2	12.5	4
			mode
	SXSC					50/125
	GBIC-	1000Mb	Single-	10	1300	9/125	-9.5	-20	8.5	17	10.5	21
			mode
LXSC10
	GBIC-	1000Mb	Single-	25	1550	9/125	-4.0	-21	15	37.5	17.5	43
			mode
LXSC25
	GBIC-	1000Mb	Single-	40	1550	9/125	-4.0	-21	15	60	17.5	70
			mode
ZXSC40
	GBIC-	1000Mb	Single-	70	1550	9/125	-3.0	-23	18	90	20.5	102
			mode
ZXSC70

*Note: The use of either multi-mode or single-mode fiber to operate at 100Mbps speed over long distances (i.e., in excess of approx. 400 meters) can be achieved only if the following factors are both applied:

•The 100Mb fiber segment must operate in full-duplex (FDX) mode, i.e. the full-duplex (factory default) setting for 100Mbps fiber ports must be used, and

•The worst-case OPB of the fiber link must be greater than the fiber cable’s

passive Attenuation.

(Attenuation = Cable loss + LED aging loss + Insertion loss + safety factor)

5.0Introduction - Magnum 6K25e Managed Fiber Switch Port Modules

This chapter describes each Port Module (PM), including appearance,

functionality, and status displays.

www . GarrettCom . com

42