Grizzly & G1022PROZX instruction manual Motor

Motor

NOTICE

Motor pictures shown are specific to the Models SM & Z. The Models ZF, ZFX, PROZ,

&PROZX will look different but will assem- ble in the same way.

To mount the motor:

1.Turn the motor upside down and attach the motor plate using M8-1.25 x 25 hex bolts, 8MM flat washers and M8-1.25 hex nuts as shown in Figure 15. Finger-tighten only.

The motor comes

pre-wired.

Motor Mount Plate

Figure 15. Attaching the motor plate.

2.Insert the 1Ú4''-20 x 2'' hex bolt through the hole in the pulley guard bracket as shown in Figure 16.

-22-

Pulley Guard Bracket

1Ú4''-20 x 2'' Hex Bolt

Figure 16. Pulley guard bracket.

3.Set the motor on end and slip the pulley guard bracket between the base of the motor and the motor plate as shown in Figure 17.

Pulley Guard Bracket

Motor Mount Plate

Figure 17. Installing pulley guard.

4.Tighten 1 of the 4 mounting bolts. Leave the other 3 loose.

5.Locate the motor mount bracket shown in Figure 18. Loosen the setscrew that holds the motor pivot rod in place and remove the rod.

G1022 Series Table Saws