IBM RS/6000 manual Running the Diagnostics from a TTY Terminal

set	up to	boot from a server, the diagnostics are run in the
are	from	disk.

ŸIf the diagnostics are loaded from disk or a server, you must

operating	system before turning	the	system	unit off to prevent
to disk	data. This is done in	one	of two	ways:

–If the diagnostics were loaded in standalone mode, press th DIAGNOSTIC OPERATING INSTRUCTIONS displays; then press the F3 key

again to shutdown the AIX operating system.

– If the diagnostics were loaded in maintenance or concurrent shutdown -Fcommand.

ŸUnder some conditions the system may stop, with instructions disp attached displays and terminals. Follow the instructions to select display.

Running the Diagnostics from a TTY Terminal

Consider the following when you run diagnostics using a TTY-type termi console display:

Ÿ See the operator manual					for	your type of tty terminal		to	find
you need		to	respond	to	the	diagnostics. For	the 3151,	refer t
Display	Station		Guide	to Operations, form number GA18-2633. For the
refer	to	the	3164	ASCII Color Display Station			Description,		form

GA18-2617.

ŸWhen the diagnostics present display information through the Seria certain attributes are used. These attributes are set as if using a 3161 display terminal. The following tables list attributes

ASCII Display Terminal and for two other ASCII display terminals used with the system.

ŸIf you have a TTY terminal other than a 3151, 3161 or 3164 Serial 1 port, your terminal may have different names for the a attribute descriptions in the following tables to determine the minal.

Chapter 6. Using the Online and Standalone Diagnostics6-3