InFocus ScreenPlay 7210 manual Connector Panel

Connector Panel

The projector provides eight discreet video connectors:

•two red-green-blue RCA (SD/ED/HD component)

•two S-video

•one composite RCA

•one M1-DA (HD, RGBHV, HD component, DVI, and computer)

•one VESA (HD, RGBHV, HD component, and computer)

•one D5 (SD/ED/HD component, RGB SCART)

It also has a mini-jack input for a Niles or Xantech-compatible IR repeater and an RS-232 connector for serial control. The Command Line Interface (CLI) specifications and commands are listed in the Appendix starting on page 37.

Two 3.5mm mini-jack triggers provide 12 volt current. Trigger 1 provides a constant output while the projector is on. For example, if you connect your projection screen to Trigger 1, when you turn on the projector the screen will move down; when you turn the projector off, the screen will return to the storage position. Trigger 2 provides a 4:3 aspect trigger. When you select 4:3 in the Aspect Ratio menu or from the Resize button on the remote, a 12v signal will be sent after a five second delay. Use this trigger for screens with 4:3 aspect curtains. When you switch back to 16:9 format, the curtains open to reveal the entire screen.

For details on each connector type and their inputs, see page 35.

	IR input
video/computer			s-video		video
1 & 2
		Y	1	Y
	IR in
M1-DA 1	vesa 2	Pb	2	Pb	7
					video
		Pr	4	Pr
	serial control
			5
			s-video
		3
		component

power

connectorcomponent serial video

connector

+12v

ground

3.5mm mono plug for 12 volt current connection

remote control

D5receiver (IR) video

12v triggers

D5 8	trigger 1
	trigger 2

lock

.

to screen relay (see screen manufacturer for details)

5