Desktop-Mounting | Intel FPC 5084, N270 guide

FPC 5084

2.4.3 Desktop-Mounting

The FPC 5084 is designed for desktop mounting application. Please refer to the following steps:

Step 1 Find out the screws as marked on the back side of chassis.

16	Hardware Installation

Image 24

Intel FPC 5084, N270 user manual Desktop-Mounting

Contents

FPC Disclaimers Safety Approvals FCC Compliance Safety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable Design Specifications Main CPU Board System Specification 2 I/O System FPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card Installation Hardware Installation Serial Ports Interface Signal Name Pin Signal Ethernet Mountings Panel/Wall/Desktop/VESA Panel Mounting Wall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation Keys Main Menu System Time/Date Advanced Menu Configure advanced CPU settings Execute-Disable Bit CapabilityMax Cpuid Value Limit Hyper Threading Technology IDE Configuration Enhanced C-States Serial Port1 Address Serial Port1 IRQSerial Port2 Address Serial Port2 IRQ Serial Port4 Address Serial Port4 IRQ Hardware Health Configuration System Temperature/CPU Temperature Acpi Settings APM Configuration Power Management/APMVideo Power Down Mode Hard Disk Drive Power Down Mode Power Button ModeSuspend Time Out Minute Throttle Slow Clock Ratio Resume On RTC Alarm Advanced Resume Event Controls Resume On Ring MPS Configuration MPS Revision PCI Express Configuration Active State Power-Management SB Pcie Ports Configuration USB Configuration USB 2.0 Controller ModeBios Ehci Hand-Off Legacy USB Support PCI PnP Menu PCI Latency Timer Clear NvramPlug & Play O/S Allocate IRQ to PCI VGA Palette Snooping PCI IDE BusMasterOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15 Boot Menu Boot Settings Configuration Quick Boot Quiet BootAddOn ROM Display Mode Boot Num-Lock Wait For ‘F1’ If Error Boot Device PriorityHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Supervisor Password User PasswordChange Supervisor Password Change User Password Boot Sector Virus Protection Chipset Menu North Bridge Configuration Dram Frequency Configure Dram Timing by SPDBoot Graphic Adapter Priority Internal Graphics Mode Select AMI Bios Setup Utility South Bridge Configuration Restore on AC Power Loss Pcie Port ConfigurationUSB Function USB 2.0 Controller Exit Menu Save Changes and ExitDiscard Changes and Exit Discard Changes Load Optimal Defaults Load Fail-Safe Defaults Chapter Drivers Installation System Specification Driver Installation- Windows XPTouch Screen FPC Installation of Drivers Embedded O.S Windows XP EmbeddedPenMount Touch screen Windows CE.NET Calibration Touch screen