Kodak 8657 manual About SCSI-connected Installations

About SCSI-connected Installations

6.Set the SCSI device number using the printer’s display panel. Changing the SCSI ID settings

a.Press Setup/Select when READY-RASTER appears in the dis- play panel.

b.Use the Print and Cancel buttons to scroll through the list until PORTS appears.

c.Press Setup/Select to access the PORTS options.

d.Press Print to scroll down (or Cancel to scroll up) through the list until SCSI appears.

e.Press Setup/Select until TARGET appears.

f.Press Setup/Select to access the TARGET ID.

g.Use the Print and Cancel buttons to scroll through the list.

h.Press Setup/Select to make your selection.

NOTE: An asterisk appears next to the number.

i.Press Cancel until EXIT appears.

j.Press Setup/Select until TARGET appears.

k.Press Cancel until EXIT appears

l.Press Setup/Select until SCSI appears.

m.Press Cancel until EXIT appears.

n.Press Setup/Select until PORTS appears.

o.Press Cancel until EXIT appears.

p.Press Setup/Select to return to Ready - Raster Mode.

q.Reboot host computer.

NOTE: The just-selected option is effective when you power the printer off and then on.

7.Run the Adaptec EZ-SCSI Software install program to install the soft- ware on your system.

Instructions for installation are included in the Adaptec EZ–SCSI for DOS/Windows, User’s Manual.

Make sure that you select the option Install ASPI For Windows and follow the instructions on the screen for that installation option.

C–2 January 1998