Lantronix 4092A IRIG-B manual Appendix a Specifications, Electrical Specifications

Appendix A: Specifications

A.3 Electrical Specifications

Table 3 lists the electrical specifications for the 4092A.

Table 3: Electrical specifications

Item	Specification
Protection Class	Class I (Grounded Type)
Power Input Voltage	100–240 V ~ 50/60 Hz 0.5 A, power dissipation ~20 Watts
		Note: Fluctuations not to exceed ± 10% of nominal supply voltage.
Power Inlet Type	IEC 60320 sheet C14
AC Power Supply Cord Set	18 AWG (0.75 mm2 minimum)
DC Power Supply	The external wiring to this connector must be at a minimum 1.5 mm² (14 AWG)
	with a 15 A fuse or circuit breaker. A 20 A circuit breaker may be used if the
	external wiring is jacketed 14 AWG, with maximum length of 20 feet. An
	internal fuse mounted on the power supply carrier board is included to protect
	this input but is not field replaceable. Mating connector for the DC power
	supply is a AMP 1-350344-0 and 2 sockets are required, AMP 350388-1.
Power Supply Part Numbers	AC: TSC 4501A
	DC: TSC 4502A
Power Mains Fuse	AC: (2) - 250V~1A time lag 5 x 20 mm. Initial shipments will have one fuse.
	DC: No customer-serviceable fuses.
Unmodulated Signal Input	„ Frequency: 1–200 kHz
	„ Lo-Z Impedance: 50 Ω ±5 Ω
	„ Hi-Z Impedance: 600 Ω ±10 Ω
	„ Input level: > 1.5 V peak to peak into 50 Ω
Modulated Signal Input	„ Code Format: IRIG-B
	„ Frequency: 1 kHz (IRIG-B)
	„ Lo-Z Impedance: 50 Ω ±5 Ω
	„ Hi-Z Impedance: 600 Ω ±10 Ω
	„ Input level: > 2.8 V peak to peak into 50 Ω
Connectors	„ Input: 2 BNC
	„ Output: 8 BNC
	„ LAN: RJ-45
Gain	0 dB
Isolation	> 70 dB

4092A Operations and Maintenance Manual 25