Installation
To install the ETS, complete the following steps in order. Refer to the numbers in the previous figure.
1.Select a location for the ETS.
When choosing a location, keep in mind the environmental restrictions discussed in E:Specifications.
2.Connect one or more serial devices to the ETS.
Note: The default serial port settings are 9600 baud, 8 bit characters, no parity, 1 stop bit, and
3.It is recommended to connect a terminal to the ETS console port (port 1). This will enable you to receive diagnostic and initial configuration messages.
4.Connect an Ethernet cable to either the
Note: The ETS will boot without a valid Ethernet connection, but it will pause to print a message (seen on the console port) asking if you want to stop at the Boot> prompt. If you do not respond to this message, it will wait for 10 seconds and then finish booting.
5.Attach one end of the power cable to the ETS and plug the other end into an electrical outlet.
6.Flip the power switch to turn the unit ON. The ETS will go through two steps to begin normal operation:
a)It runs through a set of
b)It tries to obtain TCP/IP configuration information via DHCP, BOOTP, and RARP. This may take as long as 15 seconds if no hosts answer the requests. During this step, the OK LED blinks approximately 3 times per second and the NET LED blinks occasionally.
7.Install EZWebCon on your
ETSPR Product Descriptions
ETS16PR Front Panel
The ETS16PR has 16 RJ45 serial ports, a Reset button, an AUI Ethernet port, an RJ45 Ethernet port for
Figure 2-4. ETS16PR Front Panel
Note: The first RJ45 port is also the serial console port. Use it as a method for the initial setup or troubleshooting.
ETS Installation Guide | 11 |
