McIntosh MDLP2 owner manual Config. Settings

Status Info. - Displays On-Screen information about the status of the video input signal and when other operational modes are selected. This occurs when the INFO Push-button or other push-buttons are pressed on the Remote Control.

Enable: Displays the current status for a set amount of time in the upper right- hand corner of the screen.

Disable: The information is not displayed. Power-OFF Confirm - Displays an On-Screen message

requesting confirmation after press- ing either the PROJ OFF Push- button on the Remote Control or the STANDBY/ON Push-button on the Projector Control Panel (as the push-button may have been pressed by mistake).

Disable: Switches Off power to the projector without the option provided by the confirmation message.

Enable: The confirmation message will appear after press- ing either push-button to switch power Off to the projector.

Blanking Memory - There are three memory locations capable of storing how much projected image (top/bottom/sides) will be cut off by black bands (masking) to pre- vent viewing the undesirable parts of the image.

Memory 1-3: Each of the three mem- ory locations will store and retrieve the desired masking settings.

Off: Switches Off the blank- ing mode. No masking occurs.

Config. Settings

The items in the configuration menu determine how the MDLP2 Projector interfaces with other equipment, such as motorized projection screens. There are also settings deal- ing with the MDLP2 Projection Lamp. Refer to figure 33 and your McIntosh Dealer for additional information and/ or assistance.

Auto Power Off - This feature allows for the MDLP2 to be switched Off automatically ten minutes

Standard 1
Picture Adjust	Auto Power Off		Enable
Fine Menu 1	Trigger 2 Full		On
Fine Menu 2	Trigger 2 Normal		On
Input Signal	Trigger 2	Zoom	On
RGB/HD Adjust	Trigger 2	V-stretch	On
HDMI	Trigger 2 Through		On
Display	Remote Control
OSD/Blanking	Reset Lamp Life
Config.	Reset All

Figure 33

after there is a loss of a video signal on the currently selected input, thus con- serving the projectors lamp life. Enable: This setting will activate the

feature. Approximately nine minutes after there is a loss of the video signal, an On-Screen message will appear. If the MDLP2 doesn’t receive a video signal on the currently selected input or a new command is not issued via the Control Panel or Remote Control, the MDLP2 will switch Off about one min- ute later. Refer to figure 34.

Auto Power Off

It will be standby mode soon.

Figure 34

Disable: The Auto Power Off Feature is switched Off.

Trigger 2 - Is activated by changing the Aspect Ratio (Full, Normal, Zoom, V-stretch and Through). This allows for changing the size of the reflective area of the projection screen (via motorized masking) and/or the addition of an external lens in the light path. With a given Trigger 2 (Full, Normal, Zoom, V-stretch and Through) set to ON, a 12VDC output will appear at the Trigger 2 Output Jack; when set to OFF, 0V appears at Trigger 2 Output Jack.

Remote Control - Selection includes the two built in sen- sors along with any external sensor(s) connected via the external IR Input Jack or just external sensor(s). Refer to page 5, General Information Note 6.

28