Motorola SSETM 5000 service manual Disassembly/Reassembly Procedures for Radio Knobs, Tool Comment

7-10 Disassembly/Reassembly Procedures: Disassembly/Reassembly Procedures for Radio Knobs

7.4.5Universal Connector Dust Cover

This section explains how to remove and attach the dust cover for the universal connector.

!When the universal connector is not in use, keep it covered with the dust cover.

C a u t i o n

7.4.5.1Remove the Universal Connector Dust Cover

1.Use a Phillips-head screwdriver to unscrew the screw at the top of the dust cover.

2.Pull the dust cover away and up until it is separated from the radio.

7.4.5.2Attach the Universal Connector Dust Cover

1.Hook the bottom of the dust cover into the slot on the left rear of the radio, just below the accessory connector.

2.Align the screw on the dust cover with the hole on the radio, behind the antenna connector.

3.Use a Phillips-head screwdriver to screw the dust cover firmly into place.

THREADED

HOLE

CONNECTOR

SLOT

SCREW

DUST

COVER

TAB

Figure 7-7. Attaching the Universal Connector Dust Cover

7.5Disassembly/Reassembly Procedures for Radio Knobs

NOTE: Numbers in parentheses ( ) refer to item numbers in Figure 7-1 on page 7-3and Table 7-1 on page 7-4.

Table 7-2. Tools Used for Disassembly/Reassembly

Tool	Comment	Part No.
ROTO-TORQ Tool	Adjustable torque driver	RSX4043_
Phillips Head Star Bit	Used for attaching/detaching power contact screws.	6680321B79
Channel and Volume Switch	Used for attaching/detaching volume control and channel	6680370B88
Spanner Nut Bit	select switch spanner nuts.
Antenna Spanner Nut Bit	Used for attaching/detaching antenna spanner nuts.	6680371B34
T-10 Torx Bit	Used for attaching/detaching radio bolts.	6680387A74

November 11, 2004 6881094C12-A