Dsvd Enable/Disable

MultiModemDSVD User Guide		4 AT Commands, S-Registers, and Result Codes
Command: -SSE=n		DSVD Enable/Disable
Values:		n = 0 or 1
Default:	0
Description: -SSE=0	Disable DSVD.
-SSE=1	Enable DSVD.

		Note: DSVD mode can be enabled by either the -SSE=1or the
		-SMS=1command, and disabled by either -SSE=0or -SMS=0.

Command: #BDR=n Baud Rate Select
Values:		n = 0–48
Default:	0
Description: #BDR=0		Enables autobaud detection on the serial port interface.
#BDR=n 1<n<48. Sends OK message at current speed, then switches to
		the new speed defined by n × 2400 bps unless and until an-
		other #BDR= command is received. Autobaud is disabled, and
		the character format is maintained at the format most recently
		detected.
Command: #CLS=n Data, Fax, or Voice/Audio Select
Values:	n = 0, 1, 2, or 8
Default:	0
Description: #CLS=0 Data mode: The modem acts like a data modem on subsequent
		answer or originate operations.

#CLS=1	Class 1 fax mode: Selects Class 1 fax modem operation.
#CLS=2	Class 2 fax mode: Selects Class 2 fax modem operation.
#CLS=8 Voice/audio mode: All telephone calls initialized by #CLS=8
	result, after successful call progress, in the modem operating in
	online voice command mode.
Command: #MDL? Identify Model
Values:	n/a
Description:	Displays the modem name or model.
Command: #MFR? Identify Manufacturer
Values:	n/a
Description:	Displays the name of the manufacturer.
Command: #REV?	Identify Revision Level
Values:	n/a
Description:	Displays the revision level of the modem’s firmware.
Command: #VLS=n	Voice Line Select
Values:	n = 5 or 6
Default:	5
Description: #VLS=5	Selects the headset while in #CLS=8 (voice/audio) mode.

#VLS=6 Select the speakerphone while in #CLS=8 (voice/audio) mode.

Note: The #VLS= command must be issued prior to establish- ing a DSVD connection if a voice line other than the default headset is desired.

Multi-Tech Systems MT5600DSVD manual Dsvd Enable/Disable, Command #BDR=n Baud Rate Select