Onkyo TX-NR626 En-70, Controlling Zone 2 Components, Adjusting the Volume for Zone, Muting Zone

Controlling Zone 2 Components

■Operating on the AV receiver

Input selector buttons

1

Press ZONE2, then point the remote controller at the AV receiver and press 8RECEIVER.

Zone 2 turns on, the Z2 indicator lights on the AV receiver’s display.

Advanced Operations

Tip

•To unmute, press ZONE2 followed by MUTING again. Zone can also be unmuted by adjusting the volume.

Note

ZONE 2	OFF	MASTER VOLUME
		2
		3

To select an input source for Zone 2, press ZONE2, followed by an INPUT SELECTOR button.

To turn off Zone 2, press ZONE2, followed by 8RECEIVER.

The zone is turned off.

• Only analog, NET or USB input source is output from the

ZONE 2 LINE OUT jacks and ZONE 2 L/R terminals.

• You cannot select different AM or FM radio stations for your

main room and Zone 2. The same AM/FM radio station will

be heard in each room. Namely, if you have selected an FM

station for the main room, that station will also be output in

Zone 2.

• You cannot select different input selector NET or USB for

your main room and Zone 2. Namely, if you have selected

1 To turn on Zone 2 and select an input source, press ZONE 2 followed by an input selector button within 8 seconds.

Zone 2 turns on, the Z2 indicator lights on the AV receiver’s display.

To select the same source as the main room’s, press ZONE 2 twice. “Z2 Sel: Source” appears on the AV receiver’s display.

2 To turn off Zone 2, press OFF.

The zone is turned off.

■Operating on the remote controller

To control Zone 2, you must press ZONE2 on the remote controller first.

8RECEIVER ZONE2

INPUT SELECTOR

MUTING

VOLq/w

Adjusting the Volume for Zone 2

■Operating on the remote controller

1 Press ZONE2.

2 Use VOL q/w.

■Operating on the AV receiver

1	Press ZONE 2 (the Z2 indicator on the AV
	receiver’s display flashes).
2	Use MASTER VOLUME control within 8
	seconds.

If your Zone 2 speakers are connected to a receiver or integrated amplifier in Zone 2, use its volume control to adjust the volume.

Muting Zone 2

■Operating on the remote controller

1 Press ZONE2 followed by MUTING.

USB input selector for Zone 2, USB input selector will be

selected in main room even if NET has been selected for

main room.

• BLUETOOTH cannot be selected as input selector in

Zone 2. If you play audio from Bluetooth-enabled device in

Zone 2, select “Z2 Sel: Source”, and BLUETOOTH as

input selector in Main room.

• When Zone 2 is activated and its input selector is selected,

the power consumption of standby mode slightly increases.

• While Zone 2 is on, ufunctions will not work.

• When setting the AV receiver to standby mode while

Zone 2 is active, the Z2 indicator is dimly lit.

• Activating Zones in the main room when the listening mode

is set to Pure Audio (European, Australian and Asian

models) will automatically switch it to Direct.

En-70