Panasonic AW-RL400G manual =Guide pin END/EXT connector ND/EXT, Camera mounting screws U1/4 20UNC

Indoor Pan/Tilt Head AW-PH400

Parts and their function

=Guide pin	END/EXT connector [ND/EXT]
Use this to determine the direction in which the camera is	This is for the control of the ND filter and lens extender of
to be mounted.	the motorized lens unit.
	Connect this connector when using a motorized lens unit
>Camera mounting screws (U1/4” 20UNC)	with ND filter and lens extender functions.
These are used to secure the camera firmly after it has	The compatible connector is the R03-P6M or R03-PB6M
been mounted.	made by Tajimi Electronics Co., Ltd.

ENGLISH

?Side blank panel

ND signal CVCC (+12V)

This is used when the mounting direction of the pedestal connector panel is to be changed.

A F

@SDI IN connector [SDI IN]

Use a coaxial cable to connect this to the SDI OUT connector on the AW-PB504 SDI card or other card installed in the convertible camera.

AENG LENS CONTROL connector

[ENG LENS CONTROL]

Use this when an ENG lens is to be used. An optional connecting cable is required.

ND return B E CGND

C D

EXT return

EXT signal

(Pin layout as seen from cable end)

BOPTION connector [OPTION]

The optional AW-RL400 roll unit is connected here using the cable supplied with the AW-RL400.

CLENS I/F connector [LENS I/F]

This is used to control the zooming and focusing of the motorized lens unit. Use the motorized lens unit’s remote (zoom/focus) control cable to make the connection.

DCAMERA I/F connector [CAMERA I/F]

This is used for the control of the convertible camera. Use the camera cable supplied with the AW-PH400 to connect the connector with the REMOTE connector on the camera.

Depending on the functions of the optional card, a special camera cable (sold separately) is required.

FTALLY OFF/ON switch [TALLY]

When this is set to ON, the tally lamp is lit by the selected signals. When it is set to OFF, the (6) tally lamp will not light even if the selected signals are supplied.

GCONTROL IN IP/RP connector [IP/RP]

This is the connector for the control of signals of the camera and pan/tilt head.

It is connected to the CONTROL OUT TO PAN/TILT connector on the AW-RP400 pan/tilt head controller. Use a 10BASE-T (equivalent to UTP category 5) straight cable for the connecting cable.

HVIDEO connector [VIDEO]

This the output connector for the camera’s video signals. It is connected to the Y/VIDEO connector on the AW-RC400 cable compensator or monitor, etc.

Use a BNC coaxial cable for the connecting cable.

ICABLE COMP OFF/ON switch [CABLE COMP]

When this is set to ON, signals which have been cable- compensated for the equivalent of 500 meters are output from the VIDEO connector and the Y, Pr and Pb connectors.

When this switch is used in conjunction with the AW-RC400 cable compensator, the video cable can be extended up to a maximum of 1000 meters.

8 (E)